Description The Stereo VideoMic Pro from RØDE builds on the success of the RØDE VideoMic Pro & Stereo VideoMic with improved stereo reproduction, sound quality, and ergonomic design. The Stereo VideoMic’s capsule features a matched pair of 1/2″ cardioid condenser capsules, mounted in a coincident X/Y position for accurate stereo imagery and detail. The microphone’s small, ergonomic footprint features an integrated shock mounting system for superior isolation from vibration and mechanical noise. The multi-strand output cable is terminated with a 1/8″ (3.5mm) output connector and delivers significantly lower noise transference than traditional audio cable. The included shoe mount features an integrated shock-mount system for even further protection against handling noise. The Stereo VideoMic features a high pass filter switch at 75Hz for minimizing low-frequency noise, and a -10dB Pad for maximizing headroom for capturing loud signals without distortion. The 20dB level boost switch is specifically designed to provide a higher quality signal with DSLR cameras. When activated, camera preamp level is reduced, resulting in a lower noise floor and much clearer recording. Broadcast recording quality on-camera microphone Matched pair 1/2″ condenser capsules in XY stereo configuration Ultra lightweight, compact form factor Two step High Pass Filter (flat, 75Hz) Three position level control (-10dB, 0, 20dB) 9V battery powered – over 100 hours use (alkaline) Integrated shock mounting Integrated foam windscreen 3.5mm stereo mini-jack output Billeted metal camera shoe mount with 3/8″ thread for easy boompole mounting Transducer Pressure Gradient, JFET impedance converter Polar Pattern XY Cardioid (Coincident) Frequency Range 40Hz ~ 20,000Hz (selectable HPF@75Hz) Output Impedance 200Ω Maximum Output 4.2dBu (@ 1% THD into 1kΩ) Power Supply 9V alkaline battery Connection 1/8″ (3.5mm) stereo mini-jack SPL 134dB, max (1 kHz, 1% THD into 1kΩ) Sensitivity -38dB re 1V/P (12.6mV @ 94dB SPL) ±2dB @ 1kHz EIN 20dBA SPL (A – weighted per IEC651) Dynamic Range 100dB (per IEC651) Signal to Noise Ratio 73dB SPL (A – weighted per IEC651) Dimensions 2.6 x 4.25 x 5.1″ (66 x 108 x 130 mm) Weight 4.1 oz (117 g) (without battery) Wilcox Sound is an authorized RØDE Microphones Dealer
